leads4pass offers 2017 latest Cisco CCNA 200-125 dumps exam practice materials and study guides free try. High quality Cisco CCNA 200-125 dumps vce youtube free demo. https://www.leads4pass.com/200-125.html dumps pdf training resources. Get the best Cisco CCNA 200-125 dumps exam questions and answers from leads4pass, pass Cisco 200-125 exam test easily at first attempt.
Latest Cisco CCNA 200-125 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRSnZDMkVUWDJzLWM
Latest Cisco CCNA 200-355 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRM01sZjQ2dUtRckU
Vendor: Cisco
Certifications: CCNA
Exam Name: CCNA Cisco Certified Network Associate CCNA (v3.0)
Exam Code: 200-125
Total Questions: 966 Q&As
QUESTION 1
Under normal operations, cisco recommends that you configure switch ports on which vlan?
A. on the default vlan
B. on the management vlan
C. on the native vlan
D. on any vlan except the default vlan
Correct Answer: D
QUESTION 2
Which function does IP SLA ICMP ECHO operation perform to assist with troubleshooting
A. packet-loss detection
B. congestion detection
C. hop-by-hop response time
D. one way jitter measurement
Correct Answer: C
QUESTION 3
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols? 200-125 dumps
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
Correct Answer: D
QUESTION 4
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has builtin security mechanisms?
A. HDLC
B. PPP
C. X.25
D. Frame Relay
Correct Answer: B
QUESTION 5
In which three ways is an IPv6 header simpler than an IPv4 header? (Choose three.)
A. Unlike IPv4 headers, IPv6 headers have a fixed length.
B. IPv6 uses an extension header instead of the IPv4 Fragmentation field.
C. IPv6 headers eliminate the IPv4 Checksum field.
D. IPv6 headers use the Fragment Offset field in place of the IPv4 Fragmentation field.
E. IPv6 headers use a smaller Option field size than IPv4 headers.
F. IPv6 headers use a 4-bit TTL field, and IPv4 headers use an 8-bit TTL field.
Correct Answer: ABC
QUESTION 6
Which three statements about static routing are true? (Choose three.)
A. It uses consistent route determination.
B. It is best used for small-scale deployments.
C. Routing is disrupted when links fail.
D. It requires more resources than other routing methods.
E. It is best used for large-scale deployments.
F. Routers can use update messages to reroute when links fail.
Correct Answer: ABC
QUESTION 7
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link. 200-125 dumps
The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?
A. The OSPF area is not configured properly.
B. The priority on R1 should be set higher.
C. The cost on R1 should be set higher.
D. The hello and dead timers are not configured properly.
E. A backup designated router needs to be added to the network.
F. The OSPF process ID numbers must match.
Correct Answer: D
QUESTION 8
Three switches are connected to one another via trunk ports. Assuming the default switch configuration, which switch is elected as the root bridge for the spanning-tree instance of VLAN 1?
A. the switch with the highest MAC address
B. the switch with the lowest MAC address
C. the switch with the highest IP address
D. the switch with the lowest IP address
Correct Answer: B
QUESTION 9
Which command can you enter to display the operational status of the network ports on a router?
A. show interface switchport
B. show ip interface brief
C. show running-config interface fastethernet 0/1
D. show interface status
Correct Answer: B
QUESTION 10
A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, 200-125 dumps using the fewest physical interfaces and without decreasing network performance?
A. Use a hub to connect the four VLANS with a Fast Ethernet interface on the router.
B. Add a second router to handle the VLAN traffic.
C. Add two more Fast Ethernet interfaces.
D. Implement a router-on-a-stick configuration.
Correct Answer: D
Read more: https://www.leads4pass.com/200-125.html dumps pdf questions and answers free demo.
Watch the video to learn more: https://youtu.be/nF4Ul2viODM