Month: March 2017

Download Latest Cisco 642-883 Dumps Exam Questions And Answers Free Try

March 30, 2017December 24, 2019 admin

QUESTION 1
You are implementing OSPF as the IGP using a single OSPF area design. The router memory usage for OSPF is too high. Which two methods can lower the Cisco 642-883 dumps OSPF memory usage? (Choose two.)
A. Enable OSPF synchronization
B. Implement multi-area OSPF
C. Enable OSPF sham links to reduce the number of LSAs
D. Implement route summarization on the ABRs
E. Enable route leaking between Level 1 and Level 2 areas
Correct Answer: BD

QUESTION 2
In which network environment is IS-IS adjacency check important?
A. in a multitopology environment where there are different instances of IS-IS running on the same router
B. in an IPv4/IPv6 environment and running single-topology IS-IS
C. when a level L1/L2 IS-IS router is neighboring with a Level 1 only or Level 2 only router
D. when IS-IS neighbors are in an NBMA environment like over Frame Relay
E. when IS-IS neighbors are in a broadcast environment like an Ethernet LAN
Correct Answer: B
642-883
QUESTION 3
Refer to the 642-883 pdf OSPF command exhibit.

Cisco

2017 Latest Lpi 101-400 Exam Study Guide Update Free Try

March 3, 2017 admin

QUESTION 1
Which of the following commands reboots the Lpi 101-400 exam system when using SysV init? (Choose TWO correct answers.)
A. shutdown -r now
B. shutdown -r “rebooting”
C. telinit 6
D. telinit 0
E. shutdown -k now “rebooting”
Correct Answer: AC
101-400
QUESTION 2
Which of the following are init systems used within Linux systems 101-400? (Choose THREE correct answers.)
A. startd
B. systemd
C. Upstart
D. SysInit
E. SysV init
Correct Answer: BCE

QUESTION 3
What information can the lspci command display about the system hardware? (Choose THREE correct answers.)
A. Device IRQ settings
B. PCI bus speed
C. System battery type
D. Device vendor identification
E. Ethernet MAC address
Correct Answer: ABD

QUESTION 4
Which of the 101-400 pdf following commands brings a system running SysV init into a state in which it is safe to perform maintenance tasks? (Choose TWO correct answers.)
A. shutdown -R 1 now
B. shutdown -single now
C. init 1
D. telinit 1
E. runlevel 1
Correct Answer: CD

QUESTION 5
Which of the following optionsfor the kernel’s

Lpi